April 7, 2003

Source: Ohio State University

Cultural practices that promote uniform plant establishment will help maximize corn production. Uneven plant spacing and emergence can reduce yield potential in corn. Seed should be spaced as uniformly as possible within the row to ensure maximum yields and optimal crop performance. Corn plants next to a gap in the row may produce a larger ear or additional ears (if the hybrid has a prolific tendency), compensating to some extent for missing plants. Skips can reduce yield in fields where the intended population is at or below the optimum, while doubles increase yield when populations are less than optimum. Reduced plant stands will yield better if plants are spaced uniformly than if there are large gaps in the row. As a "rule of thumb", yields are reduced an additional 5 percent if there are gaps of 4 to 6 feet in the row and an additional 2 percent for gaps of 1 to 3 feet.

Uneven corn emergence will generally have a greater impact on grain yield than uneven plant spacing. Uneven emergence affects corn performance because competition from larger, early-emerging plants decreases the yield from smaller, later-emerging plants. If the delay in emergence is less than two weeks, replanting increases yields less than 5 percent, regardless of the pattern of unevenness. However, if one-half or more of the plants in the stand emerge three weeks late or later, then replanting may increase yields up to 10 percent. Emergence delays of 10 days or more usually translate to growth stage differences of two leaves or more. When two plants differ by two leaves or more, the younger, smaller plant is more likely to be barren or produce nubbin ears. To decide whether to replant in this situation, growers should compare the expected economic return of the increased yield with both their replanting costs and the risk of emergence problems with the replanted stand.

To improve planter accuracy and enhance uniformity of emergence, consider the following:

1. Keep the planting speed within the range specified in the planter's manual.
2. Match the seed grade with the planter plate.
3. Check planters with finger pickups for wear on the back plate and brush (use a feeler gauge to check tension on the fingers, then tighten them correctly).
4. Check for wear on double-disc openers and seed tubes.
5. Make sure the sprocket settings on the planter transmission are correct.
6. Check for worn chains, stiff chain links, and improper tire pressure.
7. Make sure seed drop tubes are clean and clear of any obstructions.
8. Clean seed tube sensors if a planter monitor is being used.
9. Make sure coulters and disc openers are aligned.
10. Match the air pressure to the weight of the seed being planted.

For more information on planter adjustments to improve stand establishment in corn, consult: "Tips to Reduce Planter Performance Effects on Corn Yield" OSU Extension Fact Sheet AGF-150-01 http://ohioline.osu.edu/agf-fact/0150.html